Some fun with USSD codes *123*4*5*6#



USSD – short for Unstructured Supplementary Service Data – commands have been there since the first cellphone. They are the codes we have been using to top up airtime, buy bundles, check your credit balance, or even mobile money transactions (if you use EcoCash or TeleCash that is)

The main issue however with a lot of people is that entering, navigating menu numbers and entering them is that the process is a bit tedious. User sends command, gets response sends menu number, another response, another menu number and so forth. And if the network breaks in the middle of all that, it’s back to 0.


So how about making that process much much easier? I’ll share with you what I have learnt and now use. Please note though what I these have to be used very carefully, because if there is a mistake in the steps I’m going to share, some losses may be hard to reverse. Also, mobile money passwords, best to use caution (or avoid if not sure) as the trick will expose your pin.

The USSD commands are basically a string of codes and menu numbers in sequence followed by asterisk and finally, to have the codes processed, the hash “#”. So to buy bundles on the Econet network for example just use the following:


To check daily voice bundles


Buy airtime on ecocash (caution doing this please…)


The possibilities are limitless!  Try and enjoy.

Quick NetOne, Econet, And Telecel Airtime Recharge

You might also like

TelOne finally introduces data rollover

Goodbye LastPass, hello Bitwarden

New NetOne data bundle prices – March 2021

Cassava secretly shuts down EcoCashSave